Terms and conditions

Minimum 50% deposit; Balance is due 2 business days before Pickup. All transactions are non-changeable/refund without written approval from Pak Tat Industrial & Trading Co. Cancellation: Deposit will be used to cover Liquidated damage.
1) We accept CASH, EPS, VISA Card, MASTER Card, BoC Pay, HSBC PayMe and Bank Account Transfer. Check payment should made payable to "Pak Tat Industrial & Trading Co."
2) For bank account transfer/deposit, please transfer to our company bank account.
3) Payment should be made on due date stated.
4) $273 HKD service fee will be charged for any Non-Sufficient Fund or bounced check.
5) Shipping, Insurance and Installation are not included unless otherwise stated.

Product Maintenance:
The upholstery material should be under upholstery materials factory's warranty. Pak Tat Industrial & Trading Company does not cover apparent damage or wear caused by abusive or abnormal use or handling of the product. Any such misuse of the product as the following situations
*Tilt any chair while sitting on it.
*Rock any chair while sitting on it.
*Pull or slide any chair while sitting on it.
*Put fingers underneath any chair seat.
*Stand on any product for any purpose.
*Exceed the maximum weight of 250 pounds on any chair.
*Expose any product to water, flame, gas, and excessive heat.
*Any other abnormal use or handling not mentioned above.
*The buyer is entire understanding the natural characteristics of leather such as the hallmarks of genuine leather. Leather is imperfection products and scars or holes is generally appears.
*Natural stone do not come in any matching pattern of grain and texture.
*Wood owes its inherent beauty to variations in color, graining, and texture in its natural state. In the finishing process, our factories attempt to accent this beauty rather than subdue it. Consequently, the chairs or tabletops you receive may not be a perfect color match to our samples. Similarly, there may be minor variations in color from one chair to the next or from one part of the product to the other part of the same product even though they are finished at the same time. Because of these unique wood features, we can not accept returns or exchanges for the reasons of color variations on the wood products.

Warnings:
Users must make periodic inspections to look for damages, looseness, or signs of structural fatigue occurred in daily use and handling of our products. The inspections should include structural joints, corner blocks, welds and other points of stress, fasteners (screws, nuts, bolts, etc.) which can loosen under normal contract use. If any deficiency is found, the product should be taken out of service immediately and user needs to contact dealer from whom the product was purchased. All foams are flammable under certain conditions. Do not expose foam to flame or heat such as space heaters, open flame, unprotected lights, or smoking material. When foam is in contact with sufficient heat, combustion will occur causing smoke and gasses to be released. If such combustion occurs within an enclosed space, a danger of suffocation to the occupants exists from the depletion of oxygen. Upholstery covers may also burn and react in a similar way as foam when exposed to sufficient heat. CARE SHOULD BE EXERCISED NEAR OPEN FLAME OR WITH BURNING MATERIALS. .

Copyright © 2020 Copyright Pak Tat Industrial & Trading Company All Rights Reserved
Block A-D, G/F, Fuk Keung Industrial Building, 66-68 Tong Mei Road, Mong Kok, Kowloon, Hong Kong